Before You Book, Read This

No — the deflection board works the same for every swing speed. Slower, smoother swings are just as likely to be mismatched to an over-flexed shaft as fast swings are to an under-flexed one.

Your current clubs relevant to the fitting, the shoes you normally wear to play, and a rough idea of your typical handicap or scores if you know it.

Yes. Our demo wall carries left-handed heads across every category, and the deflection board measures a shaft the same way regardless of handedness.

Absolutely — many clients come in just to verify their current shafts actually match their swing, or to check lie angle on clubs they already own and plan to keep.

Most in-store fittings match flex off a swing-speed chart alone. We physically load and measure each candidate shaft on a deflection board before it's ever recommended.

The bay is located on Verdae Blvd in Greenville, and we regularly see golfers from across the Upstate, including Greer, Simpsonville, and Spartanburg.

Single-club sessions run 45–60 minutes. A full iron set reading runs 60–90 minutes. A complete bag reading typically takes 2–3 hours.

No. There's no purchase requirement. You keep the printed reading either way, and can decide later. If you do order, the session fee applies in full toward the build.

Most builds finish in-house within a week, since components are stocked on-site rather than ordered through an outside factory queue.

Yes. Any lie, loft, or length tweak needed within 30 days of a build is included at no extra charge as your swing settles into the new spec.

Yes — we run outside shafts across the deflection board on request, either as a standalone reading or as part of a full fitting session.