Iron Fitting
Most iron fittings check one club and assume the rest of the set matches. We put the whole set on the board, because flex drift across a set is more common than most golfers expect.
One Shaft Model, Different Flex by Club
Even within a matched shaft line, flex can drift subtly from long iron to short iron once tip trimming and length changes are applied. We check the deflection curve club by club, not just on a single sample.
Dynamic lie angle gets measured the same visit, using impact tape against a lie board, so length and lie corrections are based on where the sole is actually contacting turf — not a static setup guess.
What We Check During This Fitting
Flex Drift Across the Set
Every club in the set gets its own deflection reading, so a stiffening long iron or softening short iron gets caught before it's built.
Dynamic Lie Angle
Impact tape against a lie board shows exactly where the sole is contacting turf, club by club, at your actual swing speed.
Set Gapping
Carry distances across the set get logged to catch any club that's duplicating a neighbor's yardage instead of filling its own gap.
Check Your Whole Set, Not Just One Club
Sessions run 60–90 minutes and cover flex, lie, and gapping across the full set.